Xmega128a4u BO Testplan: Unterschied zwischen den Versionen
Zur Navigation springen
Zur Suche springen
Tesla (Diskussion | Beiträge) |
Tesla (Diskussion | Beiträge) |
||
| Zeile 12: | Zeile 12: | ||
All the functions are tested by the passive testboard. "Passive" means there is no processor on the board. The testprocess is done by the Xmega Breakout Board. | All the functions are tested by the passive testboard. "Passive" means there is no processor on the board. The testprocess is done by the Xmega Breakout Board. | ||
| − | + | == Usage == | |
| + | |||
| + | * Connect a 15 V to 30 V DC powersupply to the connector ''CON1''. On normal operation it uses on maximum 100 mA. | ||
| + | * Connect the programmer to the PDI-interface ''P1'' on the testboard. | ||
| + | * Connect an USB-cable to the USB-port ''J1'' on the testboard. | ||
| + | * Plug the Xmega Breakout Board in the ''IC1'' socket. (micro-USB-connector on the left side) | ||
| + | * Connect the micro-USB-cable to the Xmega Breakout Board. | ||
| + | * Download Software to the Controller. | ||
| + | * Check the LEDs. | ||
| + | * Unplug USB-cable and Xmega Breakout Board. | ||
Version vom 11. Oktober 2013, 19:12 Uhr
This is the explanation how to test the Xmega128a4u breakout board in mass production process.
- All pins on the two 20-pin connectors are tested against short circuit or open connection.
- The crystal is testet by starting the crystal oscillator.
- LEDs are optically tested.
- USB connector is testet against short circuit and open connection.
- USB ESD protection is testet: BAS70 diode forward voltage, Z-diode breakdown voltage
- Reference voltage capacitors are tested.
Testboard
All the functions are tested by the passive testboard. "Passive" means there is no processor on the board. The testprocess is done by the Xmega Breakout Board.
Usage
- Connect a 15 V to 30 V DC powersupply to the connector CON1. On normal operation it uses on maximum 100 mA.
- Connect the programmer to the PDI-interface P1 on the testboard.
- Connect an USB-cable to the USB-port J1 on the testboard.
- Plug the Xmega Breakout Board in the IC1 socket. (micro-USB-connector on the left side)
- Connect the micro-USB-cable to the Xmega Breakout Board.
- Download Software to the Controller.
- Check the LEDs.
- Unplug USB-cable and Xmega Breakout Board.